Turning signal problem

[sdd6131]

Anybody got this problem? I followed the MFC2 manual to set the trim, everything workinng fine but not the turning signal, it just can't work, please help?

[Gomjaba]

Mmm.. all I can say is re-re-re check all the connections .. it is SOOO easy to plug the wrong cable into the wrong socket.

[Mouton]

Assuming everything is correctly assembled the lights should work in both hazard light mode and demo mode. If not recheck all connections and then try plugging the turn signal in the reverse light socket just to make sure the LEDs and the cables are OK.

If I remember correctly you need to first lower the right stick and then turn in order for the turn signal to activate. I am not sure but it might be that the turn signal does not work when you reverse the truck. The MFU for the semis work that way and deactivates the turn signal as soon as you engage reverse. The semi MFU also requires full lock on the steering in order to activate the turn signal (instead of lowering the right stick to engage it).

[hydroliftT17]

Mouton is right, you need to first lower the right stick, and then release it. And you have to do it very quickly.

Check out the video posted her

http://www.tamiya3speed.com/forum/showthread.php?t=810

I couldn’t get my turn signals to work eider, until I found this.

[sdd6131]

i have tried everything, but only the turn signal still can't work:frusty: Anybody got this problem?

[cruser0026]

I have the same prob, even after watching the video and trying it again still no luck tho, never had this prob with the semi MFU

[chazell]

For what it's worth, I had a similar issue with my MFU-02. When I pulled the right stick down once to activate the turn signals, nothing happened regardless of how quickly the stick was pulled. What worked was to pull the right stick down twice in rapid succession. Then the turn signal worked.......every time.

Give it a try, you have nothing to loose.

[sdd6131]

Finally got it work:first: Have to move the stick fast