Snug Cap for the F350

[mcovalsk]

Hi friends, somebody knows where can I find a Snug Cap for the F350, I saw several time ago but not now.
I would appreciate any help about this.
Thanks for reading

[backtomyroots]

I got mine at Scale Hobbies - but can't seem to get the website anymore. Try an email here: info@scalehobbies.com (I dug through my Paypal Receipts and came up with that as contact info). I think the fellas name was Mike. That purchase was made in September 2007 though. Let us know !

[backtomyroots]

This is a photo of the one I purchased from Scale Hobbies (Pictured on an ongoing project).

[mcovalsk]

I got mine at Scale Hobbies - but can't seem to get the website anymore. Try an email here: info@scalehobbies.com (I dug through my Paypal Receipts and came up with that as contact info). I think the fellas name was Mike. That purchase was made in September 2007 though. Let us know !

Thanks! email sent I will commnet the answer if there is one.

[backtomyroots]

mcovalsk any luck getting a cap yet ?

:bump:

[mcovalsk]

mcovalsk any luck getting a cap yet ?

:bump:


No unfortunately still looking for, I sent an email but I didn't receive answer.
Thanks for asking

[backtomyroots]

Well, that's too bad - I know there are a few fellas on scale4x4rc forum that have built some you may get some assistance there. Good Luck !

[Suprachrgd82]

Buiding one isn't very difficult.

You will need:

Crafting/florists foam (fiberglass will not melt green foam)
Hot glue or gorilla glue
Fiberglass resin
Fiberglass cloth
Lots of wet/dry sandpaper
A good sanding block
Lots of time

Supra is working on one right now. Phase 2 is complete....
http://i4.photobucket.com/albums/y134/Suprachrgd82/hilux002.jpg

[McFig]

Buiding one isn't very difficult.

You will need:

Lots of time

Isn't this a contradiction :LOL:

[Suprachrgd82]

Isn't this a contradiction :LOL:

...only for those who consider the reciprocating motion of sanding "difficult"......Supra, for one, does not....

[Robert Davies]

...only for those who consider the reciprocating motion of sanding "difficult"......Supra, for one, does not....

...and sculpture's just knocking bits off a lump of stone.


(Hmmm... The selection of smilies on this board is alittle 'odd' to say the least...)

[Suprachrgd82]

...and sculpture's just knocking bits off a lump of stone.



Certainly....all that need be done is remove the material that is not a part of the final piece...

:bangin:

http://i4.photobucket.com/albums/y134/Suprachrgd82/hilux.jpg

[mcovalsk]

Well, that's too bad - I know there are a few fellas on scale4x4rc forum that have built some you may get some assistance there. Good Luck !

Thanks mate I will ask!

[Suprachrgd82]

"How to" build thread on Scale4x4:

http://www.scale4x4rc.org/forums/showthread.php?t=23408

Pending marketing plan:

http://www.scale4x4rc.org/forums/showthread.php?t=23362